Vannin' Home
Posted By: blkhawk611 New here - April 21st 2021 6:48 pm
Hello everyone,
I am currently rebuilding a 1992 Chevy G20 van. I am converting a mark III into camper van with stove, refrig, solar and a sink. I am currently working on all mechanical parts. I am looking for pre bent brake lines. any suggestions would help. Thank you
Posted By: SDMickey Re: New here - April 21st 2021 7:05 pm
Welcome from San Diego. Good Luck on the brake lines.
Posted By: lukester Re: New here - April 21st 2021 10:21 pm
Welcome from Florida
Posted By: Starlord Re: New here - April 21st 2021 11:50 pm
Welcome! Sorry, can't help you.
Posted By: newkirkinc1 Re: New here - April 22nd 2021 1:10 am
welcome from Pittsburgh! Don't know.
Posted By: vaNsquared Re: New here - April 23rd 2021 12:14 pm
Welcome!
Not sure about where to find pre-bent lines either
Last week I replaced some brake lines on my 1980 G20 with pre-flared lengths of nickel-copper line from the local auto parts store. I used a tubing bender to make a close copy of the original line, then did the fine adjustments by hand during installation. Will post some pics in my build thread soon
Posted By: SafariTim Re: New here - April 24th 2021 8:51 pm
Best bet is to bend them, very simple. You will also need a flaring tool.
© Vannin' Community and Forums