Well I am just as impressed by your artwork brother. I have loved drawing and building since I was a wee little guy. Looking forward to getting some of your work on shirts!!
Leakbox. Good to see your post. Man I need to take a road trip and see your talent in person. Hope you are doing well my friend. Your work is A-1 Brother.
Mickey....come on up! private message me. I still can't find a way to see the pictures of your prize.......
I will probably surf tomorrow but should be around over the weekend. If that doesn't work, let me know your potential. I'll be sure to stay 6 feet away.
Last edited by Leakbox; February 13th 2021 12:05 am.
Few bits more progress.....I ordered a 1.5" stainless angle (brushed finish to match the fridge door) that I will cut and attach to the edge along the slider step. I will have it hang over just enough to run a strand of my LED strip in it so the step will have the same lighting as the area around the roof. It is also perfect to cover both the foam insulation and plywood edge on the floor. I also spent a bunch of hours custom trimming and fitting the first two roof panels by cutting a hole for the aft sunroof and then sneaking up on the perimeter. I think the plastic bulkheads I made will work well, as the panel conforms nicely with the sunroof frame. I took these two panels and laid two plies of fiberglass on both upper and lower seams, then ground it smooth (relatively). Let me just say it would be a WHOLE lot easier with an additional set of hands to hold it up. Let's just say it's quite a sight with me laying on my back, splayed out with my feet holding certain areas and a hand another while I try to load screws to get it secured....I also discovered via a talk with Painless Performance that it appears my original ignition switch, which I used because the aftermarket one I got would not work with the dash bezel, is not sending power back to the harness when in the "acc" or "on" position. So I ordered a new actual GM switch and snap in harness, which I will now need to replace and splice in. Of course, I was able to get the bezel nice and tight when installing, but have no chance of spinning it back off without the special three-prong removal tool, so that needs to be ordered as well.
Jim & Lucy Newkirk 1965 Chevy Bad Influence 1981 Chevy-the Love Shack 2012 Chevy Van , 2020 chevy van 2020 Chevy van Sapphire Sweet. Club Vannerz. vanninvanner@comcast.net
Arianrhod:2003 Chevy Astro Black Magic: 1985 Dodge B-250 Serenity:1985 Chevy G-20 The Outcast:1983 Ford club wagon Luna 1974 VW bay window transporter Freedom:1990 Ford E-150(parts van) Outcast Vanners van club Support your local 2%