I used 2" drop spindles from a 95 Dakota. I am now running rotors from R1 Conecpts 633-40074L & 633-40074R and their pads 2551-0123-00. I do not have pictures of the new rotors installed but will get some in the near future.
I did have to shave a little on the caliper bracket on the new spindles as there was a slight clearance issue.
Also the tie rod end sit really close to the rotor but I haven't seen any issues yet.
This set up does have a bit of bump steer but I don't think it is too bad,
There are more pictures in my Flickr album.