Vanning.com logo
Boxdin
Site Navigation


Advertisements
Recent Posts
New folks
by MoJoeCustoms. December 09th 2019 11:10 pm
1976 Dodge B200
by MoJoeCustoms. December 09th 2019 11:05 pm
What Did You do To your Van Today?
by Deathorvictory. December 09th 2019 5:10 pm
Jack Durrand "Demon" J
by newkirkinc1. December 09th 2019 2:36 pm
Ram down, 98 b1500 v6
by Dw89xj. December 09th 2019 9:05 am
Dodge "Travel Seats" anyone seen them?
by sgtmopar. December 09th 2019 8:15 am
Changing Seats
by frscke1. December 09th 2019 1:19 am
Big Vans...
by Ram4ever. December 09th 2019 12:24 am
1990 Dodge B250 Ram Van Wagon AC problem
by Ram4ever. December 09th 2019 12:05 am
1975 B200 Sportsman Maxivan W.PB. Florida on Auction
by Jams. December 08th 2019 10:57 pm
Featured Links
Vanning.Com is a an authorized Amsoil Dealer


Previous Thread
Next Thread
Print Thread
Rate Thread
78 G30 Pathfinder conversion stuffed into a 92 G30 EWB #749443
June 11th 2019 2:03 am
June 11th 2019 2:03 am
Joined: Dec 2018
Posts: 28
Flagstaff, AZ
H
Hairoinn Offline OP
newbie
Hairoinn  Offline OP
newbie
H
Joined: Dec 2018
Posts: 28
Flagstaff, AZ
Started this in the new member section... current status on my build is rear end installed. New bushings. Front end in place. Also new bushings. Half welded. Complete 402 BBC was dropped in my lap last week. Current 350 is ready to be removed. Held in place by a chain wrapped around motor and a piece of angle iron sitting on jack stands in the floorboards. Steering and front brakes are not hooked up. 4 bolts will remove front axle. Lift front end of van off of front axle and roll it out. Drop it to the ground. Jack up motor and disconnect the chain. Lift van up and off of 350/4l80. Drag it out of the way. Support for safety. Finish welding. Assemble new motor, tranny, transfer case. Slide it under van and set body over it. Lift it some and chain it up. Reverse the process.....
More pix to come.

Attached Files 20190508_172427.jpg20190514_142536.jpg

85 Chevy SWB G20 292 w/ 3 on the tree (had it in high school)
78 Chevy SWB G30 350 700r4 Pathfinder 4x4 conversion (wrecked in 08)
92 Chevy EWB G30 350 4l80e (bought with 587k miles for the body. Getting transplants from wrecked 78. Then big block)
Various minis over the years.
Re: 78 G30 Pathfinder conversion stuffed into a 93 G30 EWB [Re: Hairoinn] #749559
June 12th 2019 7:03 am
June 12th 2019 7:03 am
Joined: May 2019
Posts: 52
Kennesaw
M
MXDUDE Offline
journeyman
MXDUDE  Offline
journeyman
M
Joined: May 2019
Posts: 52
Kennesaw
That is going to be sweet! Keep us updated! Out of curiosity, what tranny are you going with? Why not the 4L80?

Re: 78 G30 Pathfinder conversion stuffed into a 93 G30 EWB [Re: MXDUDE] #749604
June 12th 2019 8:31 pm
June 12th 2019 8:31 pm
Joined: Dec 2018
Posts: 28
Flagstaff, AZ
H
Hairoinn Offline OP
newbie
Hairoinn  Offline OP
newbie
H
Joined: Dec 2018
Posts: 28
Flagstaff, AZ
The 700r4 tailshaft adapter to mount a ford np205 is already on. (Proprietary pathfinder equipment company part) came from the one I wrecked. Adapter for a 4l80 is around 700 bucks. Maybe when I'm richer...

Attached Files 20181024_165020.jpg

85 Chevy SWB G20 292 w/ 3 on the tree (had it in high school)
78 Chevy SWB G30 350 700r4 Pathfinder 4x4 conversion (wrecked in 08)
92 Chevy EWB G30 350 4l80e (bought with 587k miles for the body. Getting transplants from wrecked 78. Then big block)
Various minis over the years.
Re: 78 G30 Pathfinder conversion stuffed into a 93 G30 EWB [Re: Hairoinn] #750021
June 26th 2019 4:45 am
June 26th 2019 4:45 am
Joined: Dec 2018
Posts: 28
Flagstaff, AZ
H
Hairoinn Offline OP
newbie
Hairoinn  Offline OP
newbie
H
Joined: Dec 2018
Posts: 28
Flagstaff, AZ
Friday's project was to mount the tail end of the tranny. This is the before picture. I'll get the after picture next time... had to cut the pathfinder equipment company bracket and move the tabs some. Added 2 plates to weld the body brace to. The brace on a 92 EWB is apparently in a different spot than it is on a 78 SWB. Mounted ,tightened, cut, jacked, measured, tacked, measured again, welded. It is in and solid. I'll add another piece of angle iron to the front edge to box it in later.

Attached Files 20190614_175705.jpg

85 Chevy SWB G20 292 w/ 3 on the tree (had it in high school)
78 Chevy SWB G30 350 700r4 Pathfinder 4x4 conversion (wrecked in 08)
92 Chevy EWB G30 350 4l80e (bought with 587k miles for the body. Getting transplants from wrecked 78. Then big block)
Various minis over the years.

Moderated by  Astro 

Donate


Upcoming Events
discovery
Who's Online Now
1 registered members (hammerhank), 12 guests, and 6 spiders.
Key: Admin, Global Mod, Mod
Newest Members
CLMoss, BrunoVDB, deVanaiv, Meatloaf, DeniseP
11247 Registered Users
Top Posters(30 Days)
frscke1 31
kursed 27
LOOKSLO 15
Forum Statistics
Forums68
Topics36,639
Posts525,967
Members11,247
Most Online177
May 8th, 2013

Powered by UBB.threads™ PHP Forum Software 7.6.1.1