hi all il have received the kit nice but i must remove everything for fix them so i have repair original
i have change carpet too
runs good , with the boat too
but yesterday problem on the rear axle. 10 bolt 8.50
vibrations .... when i raise the rear , i can move wheels and shaft about 3mm .....each i have a doubt it can be a clutch or a shaft worn but when you remove the cover of the axle, you have the 10 hole for bolts and 2 holes for oil return. on the right hole i see only the shaft . not the "tube". on the left hole i can see the shaft and the "tube" half of the hole so i am asking if the tube (normally welded) to the center as not move and so create this 5or 6 mm clearance. (last photography it s a googlr one but show the holes i said)
Nice rig .... where did you get those floor mats ?
SUNSHINE VANS-VAN DIEGO ADRENALIN BY THE GALLON & CHASIN RACIN ONE FOR THE DIRT & ONE FOR THE STREETS '93 CHEVY G30 454 4X4 SPORTVAN EXT 146" WB '92 CHEVY G30 454 BEAUVILLE EXT 146" WB
Nice and they are black with RED trim ! LOVE them !
SUNSHINE VANS-VAN DIEGO ADRENALIN BY THE GALLON & CHASIN RACIN ONE FOR THE DIRT & ONE FOR THE STREETS '93 CHEVY G30 454 4X4 SPORTVAN EXT 146" WB '92 CHEVY G30 454 BEAUVILLE EXT 146" WB
Im not mechanic .. with me if it drips a drop its in the shop..
SUNSHINE VANS-VAN DIEGO ADRENALIN BY THE GALLON & CHASIN RACIN ONE FOR THE DIRT & ONE FOR THE STREETS '93 CHEVY G30 454 4X4 SPORTVAN EXT 146" WB '92 CHEVY G30 454 BEAUVILLE EXT 146" WB
Not a mechanic either...know just enough to be dangerous.
The steel axle tubes are plug welded to the cast center section at these locations during manufacturing.
If those welds are intact, and seem sound, my guess would be that this is the way it was made (with more tube inside on the driver side). That's as far as my thinking takes me.