Vanning.com logo
Boxdin
Site Navigation


Advertisements
Recent Posts
WTB 68-74' Ford Econoline Sheet Metal
by Deathorvictory. November 18th 2019 10:03 pm
Bubble Windows Wanted
by infms73. November 18th 2019 9:43 pm
1977 Chevy AC rebuild
by 1983G20Van. November 18th 2019 8:57 pm
1989 G10 SWB 2wd
by Deathorvictory. November 18th 2019 8:48 pm
1979 dodge b300 Xplorer questions
by Deathorvictory. November 18th 2019 8:44 pm
Dads Van...a few changes
by DadsVan. November 18th 2019 8:29 pm
2020 calender
by Astrocreep66. November 18th 2019 8:11 pm
1969 Econoline Shorty
by Charlie99909. November 18th 2019 8:04 pm
Suggestion For Good Shocks
by OrionRaphael. November 18th 2019 6:30 pm
2020 new chevy van
by Deathorvictory. November 18th 2019 6:08 pm
Featured Links
Vanning.Com is a an authorized Amsoil Dealer


Previous Thread
Next Thread
Print Thread
Rate Thread
75 G20 driveline question #747705
April 26th 2019 4:55 pm
April 26th 2019 4:55 pm
Joined: Jul 2016
Posts: 18
north pole ak
T
trykflyr Offline OP
stranger
trykflyr  Offline OP
stranger
T
Joined: Jul 2016
Posts: 18
north pole ak
Was under my beast the other day and noticed the driveshaft just aft of the center support bearing has about 2 inches of splines showing. Just had the engine & tranny ( can I safely say tranny on here?) replaced but couldn't say for sure if it was like that prior to. I suspect it's normal for a 2 piece driveshaft, but it sure looks odd..... Thoughts from those with experience, please.

Re: 75 G20 driveline question [Re: trykflyr] #747707
April 26th 2019 5:26 pm
April 26th 2019 5:26 pm
Joined: Jun 2010
Posts: 14,529
Van Diego California
frscke1 Offline
frscke1  Offline

Joined: Jun 2010
Posts: 14,529
Van Diego California
No its not normal ... did they replace the motor/tranny with the same length motor/tranny ? bet not .. there is some play length wise for when the body floats ... like when you go over a hill the spline slides in N out. but there is only so much spline ... if you see 2" thats half of it.

My '92 G30 EXT ...an inch or less stickin out passed the carrier bearing ...

[Linked Image]

[Linked Image]





SUNSHINE VANS-VAN DIEGO
ADRENALIN BY THE GALLON & CHASIN RACIN
ONE FOR THE DIRT & ONE FOR THE STREETS
'93 CHEVY G30 454 4X4 SPORTVAN EXT 146" WB
'92 CHEVY G30 454 BEAUVILLE EXT 146" WB
Re: 75 G20 driveline question [Re: frscke1] #747710
April 26th 2019 5:43 pm
April 26th 2019 5:43 pm
Joined: Jul 2016
Posts: 18
north pole ak
T
trykflyr Offline OP
stranger
trykflyr  Offline OP
stranger
T
Joined: Jul 2016
Posts: 18
north pole ak
Thanks! I'll get back underneath and recheck, but I'm fairly certain everything was the same going back in.

Re: 75 G20 driveline question [Re: trykflyr] #747711
April 26th 2019 5:51 pm
April 26th 2019 5:51 pm
Joined: Jun 2010
Posts: 14,529
Van Diego California
frscke1 Offline
frscke1  Offline

Joined: Jun 2010
Posts: 14,529
Van Diego California
Either way I would get the rear drive shaft lengthened by an inch or so to put more of the spline back in the receiver ..... something changed different rear end ?


SUNSHINE VANS-VAN DIEGO
ADRENALIN BY THE GALLON & CHASIN RACIN
ONE FOR THE DIRT & ONE FOR THE STREETS
'93 CHEVY G30 454 4X4 SPORTVAN EXT 146" WB
'92 CHEVY G30 454 BEAUVILLE EXT 146" WB
Re: 75 G20 driveline question [Re: frscke1] #747733
April 27th 2019 12:23 pm
April 27th 2019 12:23 pm
Joined: Jul 2016
Posts: 18
north pole ak
T
trykflyr Offline OP
stranger
trykflyr  Offline OP
stranger
T
Joined: Jul 2016
Posts: 18
north pole ak
Only powertrain things I've done to it since I bought it are the engine and trans. Engine's a basic 350; it was a replacement long block. The trans, now that I think about it, was removed, rebuilt and reinstalled. I'm fairly certain it's the same unit that came out. I'll crawl under and measure the exposed splines. Not having much luck finding an acceptable dimension in any of the books I have.

Re: 75 G20 driveline question [Re: trykflyr] #747753
April 28th 2019 2:49 pm
April 28th 2019 2:49 pm
Joined: Mar 2011
Posts: 352
NY
J
jcd74 Offline
enthusiast
jcd74  Offline
enthusiast
J
Joined: Mar 2011
Posts: 352
NY
You know you made me look, mine is the same. I'm 89 g30 th400, Spicer drive shaft, Dana 70. Maybe a difference between Dana and the 14 bolt? Will try to post pick later.

Re: 75 G20 driveline question [Re: trykflyr] #747814
April 29th 2019 5:04 pm
April 29th 2019 5:04 pm
Joined: Jul 2016
Posts: 18
north pole ak
T
trykflyr Offline OP
stranger
trykflyr  Offline OP
stranger
T
Joined: Jul 2016
Posts: 18
north pole ak
Things look like they've been this way a while based on the crud pattern on the belly. I'll do some prodding at a couple shops here in town, see what the thoughts are. I'm curious....


Moderated by  Astro 

Donate


Upcoming Events
discovery
Who's Online Now
0 registered members (), 8 guests, and 3 spiders.
Key: Admin, Global Mod, Mod
Newest Members
Nighthawk, GeneralBob, salinas, Marbles44, VanMammal
11223 Registered Users
Top Posters(30 Days)
Wedgy 29
kursed 23
frscke1 20
brigrat 16
Forum Statistics
Forums68
Topics36,569
Posts525,429
Members11,223
Most Online177
May 8th, 2013

Powered by UBB.threads™ PHP Forum Software 7.6.1.1