Vanning.com logo
Boxdin
Site Navigation


Advertisements
Recent Posts
Any good threads with some pics showing molded in fender flares????
by Astrocreep66. January 17th 2019 7:13 pm
Dr. Bob's Jokes Thread
by Astrocreep66. January 17th 2019 7:07 pm
new guy intro
by Astrocreep66. January 17th 2019 7:03 pm
Sold for $59,000
by amx. January 17th 2019 6:00 pm
WTB: Driver's Seat Base For 1985 Chevy G Van
by tuner4life. January 17th 2019 4:40 pm
new here, thinking of getting a van
by Wizard78. January 17th 2019 4:14 pm
1978-1982 chevy van parting out
by jcd74. January 17th 2019 12:49 pm
NOS GM Lower body aluminum moldings for 71-80 chevy van
by black79gmc. January 17th 2019 9:51 am
Robo's Lowrider Boogie Van
by RoboforcerX2000. January 16th 2019 10:46 pm
Snowball 43 - Hosted by Moon Lite Vans
by ForPlay. January 16th 2019 7:52 pm
Featured Links
Vanning.Com is a an authorized Amsoil Dealer


Previous Thread
Next Thread
Print Thread
Rate Thread
WTB '75 Plymouth PB200 tail light lenses, sliding door parts #730589
December 11th 2017 10:35 am
December 11th 2017 10:35 am
Joined: Dec 2017
Posts: 21
State of Jefferson
L
liftarc Offline OP
stranger
liftarc  Offline OP
stranger
L
Joined: Dec 2017
Posts: 21
State of Jefferson
Hello all, first post here...

I have a new to me 75 Plymouth Voyager PB200 with 360 and 727, getting a 4bbl'ed Magnum 5.9 swap and built 727 with all TCI goodies.

I need both taillight lenses, some of the stainless trim running horizontally down the sides, misc parts for the sliding side door, and possibly some of the original badging.

I can provide a pic of my existing lens to match the part if needed and will start a build thread to upload pics of the van and progress.

Thanks people!


75 Plymouth Voyager build in progress: 5.9 Magnum with Demon 4bbl, built 727, al radiator, custom dash, custom kayak/canoe rack, solar/inverter/deep cycle setup, helper airbags, on board air, forklift-proof rear bumper....toolbox hauler/steath camper/long drawn out project.....
Re: WTB '75 Plymouth PB200 tail light lenses, sliding door parts [Re: liftarc] #730591
December 11th 2017 11:58 am
December 11th 2017 11:58 am
Joined: Dec 2001
Posts: 3,191
Connecticut
OVANNER Offline
pooh-bah
OVANNER  Offline
pooh-bah
Joined: Dec 2001
Posts: 3,191
Connecticut
The lenses will be the same as the 71-77 Dodge lenses. Other than the badge I think most will be the same.


1973 Dodge Shorty B-100

Life should not be a journey to the grave with the intention of arriving safely in a well preserve body,
but rather to skid in broadside in a cloud of smoke, thoroughly used up,
totally worn out, and proclaiming

"Wow What a Ride"

Johnny O
"O Vanners" of Connecticut! Since 1982

Re: WTB '75 Plymouth PB200 tail light lenses, sliding door parts [Re: liftarc] #730600
December 11th 2017 3:06 pm
December 11th 2017 3:06 pm
Joined: Jun 2010
Posts: 13,923
Van Diego California
frscke1 Offline
frscke1  Offline

Joined: Jun 2010
Posts: 13,923
Van Diego California
welcome to the site liftarc ...


SUNSHINE VANS-VAN DIEGO
ADRENALIN BY THE GALLON & CHASIN RACIN
ONE FOR THE DIRT & ONE FOR THE STREETS
'93 CHEVY G30 454 4X4 SPORTVAN EXT 146" WB
'92 CHEVY G30 454 BEAUVILLE EXT 146" WB
Re: WTB '75 Plymouth PB200 tail light lenses, sliding door parts [Re: liftarc] #730863
December 17th 2017 10:41 pm
December 17th 2017 10:41 pm
Joined: Dec 2017
Posts: 21
State of Jefferson
L
liftarc Offline OP
stranger
liftarc  Offline OP
stranger
L
Joined: Dec 2017
Posts: 21
State of Jefferson
I noticed basically everything but the badging is the same, thanks for the heads up OVANNER.

Thank you for the greeting, frscke1.

I am also looking for some rims, of course. I really wanted to find a set of slotted mags in 5x4.5 but have been unable to find anything reasonably priced. I'm considering converting to the later 5x5.5 to run the turbine style alloys like the ramchargers had so any leads on a set of those would be much appreciated. I'm located in northern ca but I travel all over the state and sometimes the country for work. I am willing to travel or ship if the price is right....



75 Plymouth Voyager build in progress: 5.9 Magnum with Demon 4bbl, built 727, al radiator, custom dash, custom kayak/canoe rack, solar/inverter/deep cycle setup, helper airbags, on board air, forklift-proof rear bumper....toolbox hauler/steath camper/long drawn out project.....

Moderated by  Astro 

Donate


Upcoming Events
discovery
Who's Online Now
1 registered members (Leachdog), 1 guest and 10 spiders.
Key: Admin, Global Mod, Mod
Newest Members
Noah, Delbert359, Sportsmobileguy, textual, lynchmob2000
10716 Registered Users
Top Posters(30 Days)
frscke1 37
Forum Statistics
Forums68
Topics35,198
Posts516,254
Members10,717
Most Online177
May 8th, 2013

Powered by UBB.threads™ PHP Forum Software 7.6.1.1