Vannin' Community and Forums Forums General Discussion General Discussion What Did You do To your Van Today?

Took "Big Red" for a ride today.looks like all the work turned out pretty good.
The "Flow Master Twins" sound better than the stock set up.
A couple more small things to knock out and I should be on the road for Florida next Thursday morning.....WOO HOO

.......Wookee

...........................Todays task ......Monstaliner Roll on bed liner ....before and after .....Man it's....lots of work IE: welded up extra holes ...sanded & wipes down with MEK then masked and still needs a second coat tomorrow. did the engine cover too. should be all worth it

Sorry ....Saw this thread after I posted

I have that same thing in the plans for the back of my 89.
A local street rod shop used the spray on stuff(comes with its own gun) on the underside and all of the interior metal on allot of the street rods they built.The stuff is as tough as nails and actually sound deadens the metal and seals out moisture very well.....

........Wookee

Drove it to the store and went to the beach and grilled a Rib eye....

I cleaned the ground cable connections on my 500 amp Shunt.



Those bolts have 9/16" heads. The 2 smaller flat head screws are for the sense wires which goto my battery monitor, which counts ALL amperage into and out of my batteries.



I also added another 4 awg cable from the Shunt to the House batteries. This in theory should allow more alternator current to make it into the house batteries when they are low, and the engine is turning the alternator fast enough.

i think he put that in there to rub it in, just a little, cause it sounds nice, I went to boneyard nuthin special just checkin it out bought whole set rechargeable tools at pawn shop so i can cut junkyard vans floor for my 84 Chevy's apart now i need the rechargeable grinder, yesterday, oogah horn for the 93 gmc sounds like a sick dog i need to wire in the relay and replace it with my air horn

Installed a new drag link. Steering is much better now!

Put my passenger side mirror back on and tried a can of 3M Rubber undercoating in a wheel well..To early to tell if its gonna hold up good.

yesterday , took a road trip and bought two cabinets.