I've had a bit of a change of plan with the hood scoop. I was going to create a raised section in the centre of the bonnet surrounding the scoop. So the hood stepped up about 1/4 inch surrounding the scoop. I did it like that in filler and put it on the van to see how it looked and I didn't like it.
Now I'm gonna smooth it in to the hood. I also decided to fill in the back of the scoop so it's a smoother line to the windscreen/ wiper cowl. I did this with some expanding builders foam which I shaped then laid some fibreglass over.
One more coat of filler tommorrow then putty,sanding and painting.
![[Linked Image]](https://i412.photobucket.com/albums/pp205/shagedemus/hoodscoop001.jpg)
You can see below how it used to drop down fairly steeply at the rear of the scoop. I thought it made it look too much like a bolt on ricer special.
![[Linked Image]](http://www.octane.ie/forum/attachment.php?attachmentid=6523&stc=1&d=1288252951.jpg)
![[Linked Image]](https://i412.photobucket.com/albums/pp205/shagedemus/hoodscoop002.jpg)
And here's the mesh I put underneath to keep out leaves etc. I made some plastic frames and used the mesh for strengthening bondo work. All those bolts are holding the scoop down nice and solid.
![[Linked Image]](https://i412.photobucket.com/albums/pp205/shagedemus/hoodscoop003.jpg)