Picked up a dodge in Seattle. On my way home to Minnesota. Long story.. but cracked my valve cover. It’s small, but it’s leaking. I’m in Helena MT, got it towed to the closest shop, and hoping to get back on road ASAP.

It’s Sunday, so nothing is open. Got a room for the night, and I’m going to start up on it tomorrow. Hopefully with sone guidance/help from the shop.

I’ve been looking into it a bit, and it sounds like a lot of ppl use JB weld as a temp fix until it can be replaced. Anyone have experience with this?

Not sure if the material is weld-able. Or if a welder in area would be able to do so.

Thought maybe I could get sone feedback/help from you all.
I appreciate your time!