From pannel van to passenger/camper van. So I bought 2 new t-slider windows for the rear 1/4s form C.R. Laurence. I orders them as a 30" x 30". They're about an inch smaller for the cut-out. So I measured 1 window and did a 29" x 29" cutout on the van. Some trimming and a great fit. So I did the exact same cutout on the passenger side. I was so very excited 'till I test fitted the window. Why is the hole too big!? The passenger side window is a 29" x 28" An inch shorter top to bottom. Now the flasing or rim of the window when sitting in the new hole bearly reaches the top of the hole. That window is no longer from C.R. Laurence. Other place only sell passenger as a 29" x 28".
What if I buy another driver side and install on the passenger side?? Now I'm in a bind. Any ideas?? Thanks.