Vannin' Home Forums Dodge General Discussion Engine Cover Seal

Hi Guys
After finishing the Body of my project over here in the UK I am now re-trimming and carrying out a camper van conversion.

I usually shop with Rock Auto but this time the parts catalogue is draqwing a blank.

Does anyone know where to obtain an engine cover seal kit, also can some kind soul post me a picture of what the retaining brackets look like..my van only has the 2 forward clips but not the 3 retaining brackets.

I do have the old seal so worst case I can sikaflex it back on but some new parts would be beneficial

its been a while since i posted but here are some before .. during and after shots.










van is now a rolling resto, saving up for some daisy mags to go on to fill the arches a little better.

Cheers
Neil.

I think it looks great man! Not sure about the rest for ya but very clean looking

It's getting harder and harder to find the engine cover gasket. It was discontinued by Chrysler long ago. I was able to find one for my 85 in Florida after a guy in Arizona told me he wouldn't sell me the one he had.

I'm at work right now, but I can post the factory part number and you can do a serch via Parts Voice.

www.partsvoice.com

The seals were pretty much the same from 78-97.

Cheers Nate.
if anyone could post a pic of the brackets which hold the cover down on the floorpan I would be grateful. They don't look too complex to make if I have too

Would be nice to know what they look like though.

N.

I'll snap a pic of those brackets when I get home from work this afternoon. My 94 only uses two of them.

Factory part number for the engine cover seal is 4166686 or 55055855AA

Try searching

www.partsvoice.com


Pics of clamps...

Thats Brilliant.
Thanks for that Nate.
Neil.