Ok a little up date I been jumping back and forth because I find I get bored in one spot for to long .
The HD buckets are done a little finish body work and i'm good .
I spent an hour last night contemplating how im doing the front end .
today I made a wheel well buck that will hold my outer ring to the frame of the wheel well flare . I then cut out and inch and 1/4 off the back on both sides inner and outer .
I was going to start to weld it up I used round bar and I ended up cutting it out as it was not going in the direction I wanted . I really need to get my self a shrinker -stretcher tool,to make lips with . So I cut the round bar out before I went to far .
It was really hot and Humid I took a brake and I came back out to the garage and started to move stuff around . I had this J&J door that was cut for a chop that was never used . I been looking for and idea for it just to use it and I may have found it ...
I think it would be cool to have a clam shell door here ? It will be a little shorter I was just seeing how it looks . The top will be metal and the bottom fiberglass .