well i been working on the chevy on and off to get it ready for paint . One of the things i wanted to do was remove the tear drop port holes mostly because they where facing backwards.
At any rate to close them up right i would have to gut the interior and weld them up slowly . Not wanting to remover the interior i decided to try the 3M panel bonding stuff . I figured how hard can it be?
well i was a little frazeld i had a hard time getting the self tapers in mostly because of the 1/4 inch drive tool i had was not the best .
It proved to be more stressfull then i had expected.
My numatic flanger crapped out on me so i ha to do it by hand .
here's the panel screwed in i'm not overly happy with it .
the drivers side i flanged the body the pasenger side i flanged the panel and stuck it on the inside . I should have done that to the driver's side as it has some high spots . if i can't fix it i'll remove it and start over .
Here's the pasenger side ..