Thanks.
With a new TIGHT true roller chain set it will be what I set it for.
I am getting a lot of info and also on a chevy group adn they are saying that cam is a limp string adn I really should get a better cam.
But the cam makers all shift the RPM range up to give more HP, any know of a good cam that torques at around 2000 RPM.
Thr Crane Roller Tip are suppost to be the same as non rollers.
Well I though I had bought a Romulator but after 10 days and no show I started a protest with paypal...
I was going to roll my own...
Rich
BTW Rich, good luck with this project.
4 degrees is quite a bit and you'll already have an under drive, you'll run past the torque peak pretty quick. If I were you, I'd degree the cam with the stock set-up during assembly, compare that to the design specs, and then decide. You may be a degree or so advanced/retarded already, as the cams, gears and chain can sometimes be. You could also compare stock rockers to the roller tips in relation to valve lift.
What's your plans on the ECM programming?